top of page
dlpng_com__Soap_Bubbles_PNG_Transparent_HD_Photo_46867_edited_edited.png
Screenshot_19-1-2025_145814_uk.rs-online.com.jpeg
        Basic Boat care and maintenance
  • Wash regularly
  • Once a year at least wash out inside (use a weak solution of bi-carb* and distilled water), rinse thoroughlySource: Sailboat RC
      *Good indigestion remedy as well !
  • Transmitter switches - hard to get to so one way to treat from experience is to liberally apply a good quality all in one switch cleaner and lubricant from the outside, leaving the TX on its back for the product to find its way into the switch contacts. A day or three usually is sufficient with re-treatment in between. 
     
33413-RS | CRC Contact Clean & Protect Electrical Contact Cleaner 250 ml Aerosol | RS
 How does this work?  The aerosol consists of
a evaporative carrier (ethanol or similar) base
which transports the cleaning solvents surface protection agent and lubricant. 
As the carrier evaporates its leaves behind a
clean surface on which the protectors and
lubricants remain.  
Perfect solution to protect RX pins and plugs from corrosion - Very high melting point (200c)
Silicon Grease


 
Corrosion inhibitor
Corrosion x


 
 
Radio receiver Ciruit Board protection - use a
Silicon based conformal coating,
it's resistance to salt water and
humidity is significantly better
than acrylic based versions
MG Chemicals 422C Silicone Conformal Coating 55ml
Aerosol versions are available:
DCA200H ELECTROLUBE, Coating, Conformal, SCC3, Silicone Resin, -70 to 200°C, Transparent, Aerosol, 200 ml | Farnell® UK    

 
mgcc00021-001_1.jpg
 
Futaba Service 

J Perkins

01622 854300

bottom of page